Usl JSD-100 Installation Manual download pdf (Page 20)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 19 of 42

3.1 SX-2000 configuration

3.1.1 Server IP Setup

The IP address of the two network interface cards (NIC) on the SX-2000 server needs to be set

for proper operation. When configuring the NICs please keep in mind that eth0 is used for

projector communication and eth1 is used for the media network.

1 Click the power button once to access the [Control Panel]. You can also access the

Control Panel by selecting the [Control Panel] button from the SMS.

2 Click [Admin Panel] to access the Admin Panel Page.

3 Click [Focus] at the far bottom right of the keyboard, then click the cursor in the

“Password” text box to enter the password.

4 Select [Network]->[Network Setup]. This opens up a page displaying the Ethernet

connections of the two NICs. (eth0 is used to communicate with the projector and

eth1 is used for network access)

5 Highlight the NIC you wish to configure and click [Select] to view and change the

network configuration settings for this NIC. In this case, the NIC eth0 was chosen

(See Figure 22)

Figure 22 Network settings for eth0

6 Once the settings have been entered, click [OK] and a small window will appear to

prompt you to “Restart network service”. Click [OK] to confirm.

7 Repeat steps 5 and 6 to configure the other NIC.

Note:

The Series 2 projector has to be booted up and ready first before SX

2000A is powered

on. The indication of Series 2 projector being ready is that the three LED lights (OS, FMT, ICP)

should be constantly green and the LED light (SOFT) should be blinking green.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

No comments

Usl JSD-100 Installation Manual Page 20