Usl JSD-100 Installation Manual download pdf (Page 36)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 35 of 42

3.3.7 Automation setup for JNIOR devices

The SX-2000 server supports the JNIOR Model 310 automation device. Follow the steps below to

configure a JNIOR device in the server automation interface.

1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this

case, it is “JNIOR”. Set the device type to “JNIOR_IO” (see Figure 38).

2. Click [OK] and set up the device parameters for the JNIOR device.

3. Enter the IP address of the JNIOR device (see Figure 39).

4. The settings for ‘Port’, ‘Login’ and ‘Password’ are set to the default values for JNIOR

devices if left empty.

5. Click the [Save] button to save configured settings.

Figure 38 JNIOR automation device setup

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42

No comments

Usl JSD-100 Installation Manual Page 36